2 Phase Series
| 2 Phase Stepper Motors | ||
PF 2-Phase High Torque Stepper Motors | ||
 | Six leads for various wiring configurations Wide selection range to suit various applications Highly cost effective | |
PS 2-Phase Standard Stepper Motors | ||
 | Six leads for various wiring configurations Wide selection range to suit various applications Highly cost effective | |
| AC supply input, High Torque and High Performance Driver | ||
INS20 AC series 2 Phase NanoDrive™ Driver | ||
 | Up to 200,000ppr 100~120Vac Single Phase Power Input High resolutions selection Maintains maximum torque Up to 2.0A/phase output | |
IMS20 AC 2 Phase Stepping Motor | ||
 | Constant current chopper, maximum 2A/phase Motor current shut off signal Clock input selection Auto current down function Low power consumption | |
| 24Vdc supply input, High Torque and High Performance Driver | ||
INS200 DC series 2 Phase NanoDrive™ Driver | ||
 | Up to 200,000ppr 24Vdc~36Vdc supply input Extremely low vibration & no hunting problems Maintains high torque Up to 2.0A/phase output | |
IMS200 DC 2 Phase Stepping Motor | ||
 | High Revolutions (4 different settings) Low Vibration Maintain Maximum Torque Input Pulse Selection (Bi-Clock/Gate) DC 24V input | |
SND100 series 2 Phase NanoDrive™ Driver | ||
 | Up to 200,000ppr 24Vdc~36Vdc supply input Extremely low vibration & no hunting problems Maintains high torque Up to 2.0A/phase output | |
SD215 Bipolar Chopper Stepping Motor Driver | ||
 | Up to 1.2A per phase 12Vdc~36Vdc supply input 20KHz chopping rate Automatic current reduction in standby mode Stepping: 1/1(full), 1/2(half) | |
SD230 Bipolar Chopper Stepping Motor Driver | ||
 | Up to 3.0 per phase 12Vdc~50Vdc supply input 20KHz chopping rate Automatic current reduction in standby mode Stepping: 1/1(full), 1/2(half), 1/4(quarter), 1/8 | |
PLG240 2-Phase/4-Phase Driver/Controller | ||
 | 150 complex instruction lines capacity 32 sets of motion parameters Emergency stop input Constant Speed movement or Indexed movement I/O Control | Timer | Loop control | Set Current | |
SD275: MicroStep 6-Amp Driver | ||
 | Accepts pulses and direction signals Generates up to 6 A of continuous current per phase. Resolution settings range from 200 steps-per-revolution at 1.8º to 10,000 steps-per-revolution at 0.036º Heat-sink chip provides thermal management. | |